Specifications:
Model: FX1N-20mr
Working Voltage: DC 24V
Wide Power Supply Voltage: 10-28V DC
Baud Rate: 9600
Programming Software: for GX-Developer for GX-work2.
Size: Approx. 86 x 73 x 20mm / 3.4 x 2.9 x 0.7inch

Module Function:
This module is programmable control can achieve thousands of functions stable and reliable working performance built-in watchdog timer circuit to ensure that the module for a long time to run!!!
Some of the common features are shown as follows:
Turn on the power supply the relay 1 is closed for N seconds and then disconnect the relay 2 for N seconds.
When the power supply is turned on the relay 1 is switched off after N seconds and then the relay 2 is closed for N seconds and then is turned off.
The power supply is switched on the relay 1 2 have no action when a signal or trigger button relay 1 closed off after N seconds; then relay 2 closed off after N seconds until the next trigger repeat the same action.
Through the signal 1 2 programming the control can be achieved on the relay 1 and 2 arbitrarily.
When the signal 1 has a signal the relay 1 is closed the relay 2 is disconnected; when the signal 2 has a signal the relay 1 is turned off and the relay 2 is closed.
Can be connected to the NPN sensor signal the sensor signal programming to achieve arbitrary control of the relay.
When the signal 1 is triggered the relay 1 is controlled and when the signal 2 is triggered the relay 2 is controlled.
Turn on the power supply the control motor is turning N seconds and then reverse N seconds followed by the cycle.
When the signal 1 has a signal the motor is controlled to rotate; when the signal 2 has a signal the motor is reversed.
These are just some examples modules can achieve far more than these functions Input high speed pulse C235 C251 and FX1N compatible.
Output relay 1A output Rated current 5A can directly drive DC solenoid valve AC solenoid valve AC contactor AC motor etc.

Precautions for Use:
The PLC with two programming port. The 232 interface you can directly use the USB-232 serial port with a computer to download the program directly. The TTL interface.
Built-in Analog input AD corresponding to internal data register D5030.(Not D8030)
Built-in Analog output DA corresponding to internal data register D5101.
When the PLC need to connect with the touch screen or text can be used to connect 232 programming port.

Assistant Relay Normal UseM0 - M383
　Hold After Power OffM384-M1535
　Special UseM8000-M8255
State Holding UseS0-S999
Timer 100MST0-T199
　10MST200-T245
　1MST246-T249
　100MS accumulationT250-T255
Counter 16-bitC0-C15
(0-32767)
　16-bit(Hold After Power Off) C16-C199
　High Speed(Hold After Power Off) C200-C255
Data Register16-bitD0-D127
　16-bit(Hold After Power Off) D128-D5029
　16-bit Special Use(AD)D5030
(Output Voltage: 0-10V)
　16-bit Special Use(DA)D5101
(Output Voltage: 0-3.3V)