K1 Relay Switch 1 Channel One Way Servo สัญญาณสําหรับเครื่องบินควบคุมระยะไกล

High Voltage 1CH PWM Signal Relay Switch Navigation Light Controller for Aircraft Remote Control Relay RC Toy

Description:
Small size and light weight
Adopt transparent heat-shrinkable rubber stylish appearance at a glance
Input channels do not need to be calibrated compatible with various brands of remote control devices
With boot protection easy to operate
Support 5-9v high voltage receivers.
1 channel servo signal input control one way electronic switch
Maximum 10A30VDC
Two LEDs indicate working status
Increased no signal protection

Application range:
Remote control model rocket launch
Remote control model smoke control
Weapon system control like real machine
Model aircrafts smoke control
Control of various remote switch systems
Switch the signals of two cameras
Control the opening and closing of various electrical power sources such as navigation lights searchlights strobe lights buzzers etc.
Control the camera shutter or switch the cameras recording and camera mode.

Functional Description:
The remote switch remotely controls the electrical equipment on the aircraft model through a switch channel on the remote control and the 1-way LED dynamically demonstrates the current switch state in real time so it can be quickly started without an operation manual.
This device does not require calibration and can be accurately compatible with remote control devices of various brands.


Typical application:
1.Connect
Plug the signal input cable into an idle receiver channel (recommended for the two-stage switch channel) which corresponds to a switch on the remote control.
The red indicator light will be illuminated when connected to the receiver.
The blue work indicator lights up when the switch channel is open and vice versa.

2. Working mode
The red LED is always on; the signal is normal. The red LED light flashes; no signal.
The blue LED indicates the relays operating status.

3. Trigger
Turn the switch on the remote control (OFF->ON) the blue LED lights up and the relay starts to work.
Turn the switch on the remote control off (ON-> OFF) the blue LED will go out and the relay will not work.

Package:
1x K1 Relay Switch