Ne555 โมดูลเครื่องกําเนิดไฟฟ้าความถี่ชีพจร 10Khz -200Khz สําหรับ Arduino Diy

NE555-Red：



1 Size: 3.1CM * 2.2CM 1 the main chip: NE555;

2 Input voltage: 5V-15VDC. 5V power supply the output current can 15MA around; 12V power supply the output current can 35MA around;

3 the input current: 100MA

4 the output amplitude: 4.2V V-PP to 11.4V V-PP. (Different depending on the input voltage the output amplitude will be different)

5 the maximum output current: 15MA (5V power supply V-PP greater than 50%) 35MA (12V power supply V-PP greater than 50%)



The scope of this module:

1 is used as a square wave signal generator generates a square wave signal used for experimental development.

2 to drive a stepper motor for generating a square wave drive signal.

3 adjustable pulse generated for use by MCU.

4 adjustable pulse generation control circuitry associated.

Advantages: 1 the output with LED indication there is no output straightforward (low LED volume high LED off frequency is relatively low the LED flashes);

2 the output level selectable frequency range the output frequency is more continuously adjustable; LF file: 1Hz ~ 50Hz IF file: 50Hz ~ 1kHz High-frequency file: 1KHz ~ 10kHz HF file: 10kHz ~ 200kHz

3 the output duty cycle can fine-tune duty cycle and frequency is not separately adjustable adjusting the duty cycle will change the frequency

4 the output frequency is adjustable; Period T = 0.7 (RA +2 RB) C RA RB is 0-10K adjustable; Low profile when C = 0.001UF; IF stalls C = 0.1UF; High-frequency file C = 1UF; HF stalls C = 100UF so the frequency of the waveform buyers can own calculations



NE555-Blue：



1. Onboard NE555 IC.

2. Single channel signal output the output duty cycle about 50% square wave.

3. Plate load resistor adjust the resistance to control the output frequency.

4. Onboard power indicator. 5. Working voltage: 5V~12V.