W5100 Shield for Arduino Ethernet SD Card Expansion

W5100 Shield for Arduino Ethernet SD Card Expansion W5100 Shield ตัวนี้เสียบกับบอร์ด Arduino จะทำให้สามารถเชื่อมต่ออินเตอร์เน็ตจากภายนอกได้ ผ่านทางช่องสายแลน มาพร้อมช่องเสียบ SD Card สำหรับบันทึกข้อมูลที่ต้องการลงหน่วยความจำ SD Card ได้ในตัว พร้อมรองรับ Arduino Duemilanove Arduino Uno Arduino Mega รองรับการใช้ library SD Card
W5100 Shield for Arduino Overview
The Arduino Ethernet Shield connects your Arduino to the internet in mere minutes. Just plug this module onto your Arduino board connect it to your network with an RJ45 cable (not included) and follow a few simple instructions to start controlling your world through the internet. As always with Arduino every element of the platform hardware software and documentation is freely available and open-source. This means you can learn exactly how its made and use its design as the starting point for your own circuits. Hundreds of thousands of Arduino boards are already fueling peoples creativity all over the world everyday. Join us now Arduino is you!
- Requires an Arduino board (not included)
- Operating voltage 5V (supplied from the Arduino Board)
- Ethernet Controller: W5100 with internal 16K buffer
- Connection speed: 10/100Mb
- Connection with Arduino on SPI port

Arduino Ethernet Shield W5100 Description The Arduino Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100ethernet chip (datasheet). The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield. The ethernet shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top.
The most recent revision of the board exposes the 1.0 pinout on rev 3 of the Arduino UNO board.
The Ethernet Shield has a standard RJ-45 connection with an integrated line transformer and Power over Ethernet enabled.
There is an onboard micro-SD card slot which can be used to store files for serving over the network. It is compatible with all the Arduino/Genuino boards. The on-board micro SD card reader is accessible through the SD Library. When working with this library SS is on Pin 4. The original revision of the shield contained a full-size SD card slot; this is not supported.
The shield also includes a reset controller to ensure that the W5100 Ethernet module is properly reset on power-up. Previous revisions of the shield were not compatible with the Mega and need to be manually reset after power-up.
Download: arduino-ethernet-shield-06-schematic.pdf arduino-ethernet-shield-06-reference-design.zip
The shield provides a standard RJ45 ethernet jack.
The reset button on the shield resets both the W5100 and the Arduino board.
The shield contains a number of informational LEDs: - PWR: indicates that the board and shield are powered
- LINK: indicates the presence of a network link and flashes when the shield transmits or receives data
- FULLD: indicates that the network connection is full duplex
- 100M: indicates the presence of a 100 Mb/s network connection (as opposed to 10 Mb/s)
- RX: flashes when the shield receives data
- TX: flashes when the shield sends data
- COLL: flashes when network collisions are detected
The solder jumper marked INT can be connected to allow the Arduino board to receive interrupt-driven notification of events from the W5100 but this is not supported by the Ethernet library. The jumper connects the INT pin of the W5100 to digital pin 2 of the Arduino.
See also: getting started with the ethernet shield and Ethernet library reference

-